LG LW76 Series Installation Manual page 24

24
INSTALLATION MENU
y Type of Connector: D-Sub 9-Pin Male
1
6
Male connector on box,
viewed towards connector.
One Channel Map
- If 'One Channel Map' is 'Yes', the TV will operate as below.
y A. When the TV is auto-scanning, it searches both air and cable channels.
y B. User can assign a channel number him/herself by manual scan.
y C. In 'Programme Edit' window, all channels are shown in a single list regardless of input
source. (DTV/RADIO/TV/Cable DTV)
y D. Automatically scanned channels may not have the user-desired channel numbers.
- If user change the 'Yes/No' value, an pop-up window will be displayed to warn that all channel
information will be deleted. The Default value is 'Yes'.
dTV Programme update
- It is a mode to set whether to update DTV programme automatically or not.
When DTV Programme Update is set to 'Auto', the function to update TV's programme map
according to dtv programme's stream information.
DTV Programme Update is set to 'Manual', the function to keep TV's programme map even
though DTV programme's information is changed.
On Timer Operation
- It is a mode to select 'On Timer Operation' working one time or repeatedly.
'ONE' : 'On Time' in the user menu operates only one time when the 'On Time' menu is set to 'ON'.
'Repeat' : 'On Time' operates repeatedly when the 'On Time' menu is set to 'ON'.
Scart Out
- The monitor out signals can or cannot be output through the SCART cable, depending on the
setting value of scar t out.You can set to Enable or Disable using the < > button. The default
value is Enable.
radio Name display
- Instead of "Audio Only", the name of a radio channel is displayed on the screen when a radio
broadcast is playing.
- Set to Yes(Work) or No(Do Not Work).
- If the setting is "Yes", the name of a radio channel is displayed for the radio channel.
- If the setting is "No", the text "Audio Only" is displayed for the radio channel.
No. Signal
5
1 VCC
2 RX RS232
3 TX RS232
4 IR from TV
5 GND
9
6, 8 Not connected
7 2 A
9 1.5 A
Signal requirements
Standard RS232 specification
Standard RS232 specification
Power ground
+5VDC 10%, max 100mV ripple
+12VDC 10%, max 100mV ripple