Optical Drive; Removing The Optical Drive Blank And Filler - Dell PowerEdge T130 Owner's Manual
Hide thumbs
Also See for PowerEdge T130:
- Getting started (2 pages) ,
- Owner's manual (117 pages) ,
- Owner's manual (120 pages)
Table of Contents
Advertisement
About this task
When 4 TB hard drives are used in a system without a PERC controller, the speed of the cooling fan
needs to be manually adjusted to prevent the hard drives from overheating.
Steps
1.
To enter the iDRAC menu, press F2 or F11 during post.
2.
Select iDRAC setting.
3.
Select Thermal section.
4.
Select Fan Setup setting.
5.
At the Fan Speed Offset section, select Low fan speed offset (+15%).
Optical drive
Removing the optical drive blank and filler
The optical drive blank is on the bezel and the optical drive filler is located in the optical drive slot on the
hard drive cage.
Prerequisites
1.
Ensure that you follow the
2.
Follow the procedure listed in
3.
Disconnect all peripherals connected to the control panel assembly.
4.
Remove the bezel.
5.
If connected, disconnect the power and data cable from the optical drive and hard drives.
6.
Remove the hard drive cage.
Steps
1.
On the bezel, press down on the retention clip of the optical drive blank and pull the blank out of the
bezel.
58
Safety
instructions.
Before working inside your
system.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
