Motorola ME-560M User Manual page 34

Range:
Default:
S2 ASCII Value of Escape Character
S2 stores the ASCII value of the escape character. Setting register S2 to a value greater than
127 disables the escape command and you cannot return to the commandstate. With escape
disabled, in the on-line state the modem cannot hang up until the power is turned off or the
remote modem hangs up.
Range:
Default:
S3 ASCII Value of Carriage Return
S3 stores the ASCII value of the carriage return character. (Pertains to asynchronous operation
only.)
Range:
Default: 13
S4 ASCII Value of Line Feed Character
S4 stores the ASCII value of the line feed character, if your computer does not recognize the
default as a line feed, change the value. A value greater than 127 disables the line feed. When
disabled, the line feed character that precedes or follows a result code is canceled.(Pertains to
asynchronous operation only.)
Range:
Default:
S5 ASCII Value of Backspace Character
S5 stores the ASCII value of the backspace character. The backspace is used to edit a command
line. If your computer does not recognize the default as a backspace, change the value. (Pertains
to asynchronous operation only.)
Set S5 to any value from 0 to 31 or 127. Do not set it to any value from 32 through 126 because
these values correspond to printable ASCII characters. A value greater than 127 disable the
backspace and makes it impossible to edit a command line.
Range:
Default:
S6 Wait Time before Blind Dialing
S6 controls how long the modem waits after it goes off-hook before it dials the first digit of the
telephone number. The modem always pauses for at least 2 seconds, even if S6 is set to less
than two seconds.
0 - 255 rings
0
0 - 255, ASCII decimal.
43 (+)
0 - 127, ASCII decimal.
0 - 127, ASCII decimal.
10 (Line Feed)
0 - 32, ASCII decimal.
8 (Backspace)