Table of Contents
Advertisement
Ln - Speaker Volume
Mn - Speaker Control
Nn - Automode Enable
0n - Return to Online Data Mode
P - Set Pulse Dial
Qn - Quiet Results Codes
Sn - Read/write S-Register
n
n=v
n?
T -Set Tone Dial
Vn - Result Code Form
Wn - Connect Message Control
Xn - Extended Result Codes
Yn - Long Space Disconnect
Zn - Soft Reset and Restore Profile
3=firmware version **
4=oem identifier (LEO 56K External) **
5=country code
6=responds with Error
7=responds with Error
where ** denotes customizable parameter.
0=low
1=low*
2=medium
3=high
0=speaker always off
1=speaker on during call establishment, but off when receiving
carrier*.
2=speaker always on.
3=Responds with OK but does nothing.
0=disable, forcing +MS=56,0,60000,60000,0,0
1=enable, forcing +MS=56,1,300,60000,0,0
0=return to online without retrain
1=return to online with retrain
0=enable result code returned*
1=disable result code returned
2=returned only in originate mode
From 0 to 95
default tone dial*
0=short form
1=long form*
0=upon connection, modem reports only the DTE speed*.
1=upon connection, modem reports error correction protocol and
DTE speed.
2=upon connection, modem reports DCE speed.
Note that the connect message response is a function of Wn, Xn
and \Vn. See Table 3.24 for detail.
0=blind dial, no busy detect, CONNECT.
1=blind dial, no busy detect, CONNECT XXXX.
2=dial tone detect, no busy detect, CONNECT XXXX.
3=blind dial, busy detect, CONNECT XXXX.
4=full monitor, all messages*, CONNECT XXXX.
Where XXXX = DTE rate or DCE rate.
Note that the connect message response is a function of Wn, Xn
and \Vn. See Table 3.24 for detail.
0=Responds with OK but does nothing.
1=Responds with OK but does nothing.
0=soft reset & restore profile 0
1=soft reset & restore profile 1
Advertisement
Table of Contents
