Table of Contents
Advertisement
DEVICE
WALL MOUNTING:
1. Drill pilot holes.
DEVICE / APPAREIL
30°
30°
5-10cm
IR
3. Insert two screws into the anchors.
Leave 1/8" length for mounting the
Transmitter or receiver.
4.
LED Behavior
TROUBLESHOOTING SCREEN:
Will appear if Transmitter is not found after 60 seconds.
PAIRING MODE SCREEN:
Receiver has entered manual pairing mode.
2. insert the supplied two Anchors into
the wall.
WHEN CONNECTED:
LED will remain solid white permanently
WHEN NOT CONNECTED:
LED will turn on for 1 second, then off for
3 seconds and repeat
5. Place NAVS502 main holes over the
protruding screws and slide down into
position
7
Advertisement
Table of Contents
