Loading Setting Data - Sony PMW-400K Operating Instructions Manual

select "Execute." In this case, the file is not saved
to the SxS memory card.
Error message
NG:Cannot Save No recordable
NG:Media Full
When using a USB flash drive (in UDF/exFAT
mode)
Connect a formatted USB flash drive (see
page 64) to the external device connector.
Select "All Save USB" > "Execute" in step 2.
To assign names to files
Assigning a name before you save data in an ALL
file can make it easier to distinguish your files.
The following characters can be used in file
names.
Alphanumeric characters (a–z, A–Z, 0–9) and
special characters ( ! # $ % & ' ( ) * + , - . / : ; < =
> ? @ [ \ ] ~)
1
Select "FILE" > "All" > "File ID" in the
setup menu.
2
Turn the MENU knob to select a
character, and then press the MENU
knob.
3
Repeat step 3.
4
When you have finished entering
characters, press the MENU knob to
move the cursor to "SET," and then
press the MENU knob.
The specified name is displayed.
When you save the file (see page 163), the
data will be saved under this name.

Loading Setting Data

Note
When you load a file from an SxS memory card
or USB flash drive (in UDF mode), the data saved
in the camcorder's internal memory is
overwritten.
See "Basic Setup Menu Operations" (page 110) for
information about menu operations.
164 Saving and Loading Settings
Problem What to do
Insert
media is recordable
inserted. media.
The media is Use media with
full. free capacity
remaining.
1
Select "FILE" > "All" in the setup
menu.
2
Select "All Load SxS" > "Execute."
A list box of ALL files appears.
File numbers where "No File" is displayed
are empty file numbers. File numbers with a
file name or a date and time are the number
of files that already contain data.
3
Turn the MENU knob to select the
desired file number.
4
Press the MENU knob.
A confirmation message appears.
5
To execute the load, select "Execute,"
and then press the MENU knob.
To cancel the load, select "Cancel," and
then press the MENU knob.
If you choose to execute the load, the
ACCESS lamp lights (in blue on the right-
side panel and in orange in the card slot
section). The ACCESS lamp goes out and a
completion message appears when the data
has been loaded from the SxS memory card.
If an error message appears
One of the following error messages may appear
during execution of the load, or as soon as you
select "Execute." In this case, the file is not
loaded from the SxS memory card.
Error message Problem
NG:No Data • There is no
readable
media
• The specified
file does not
exist on the
media
When using a USB flash drive (in UDF/exFAT
mode)
Connect a formatted USB flash drive (see
page 64) to the external device connector.
Select "All Load USB" > "Execute" in step 2.
What to do
Insert the
media that
contains the file
you want.