Wolfgang Puck BIFCM010 User Manual page 10

User Interface (Cont.)
Tank Empty
1 Single Cup Dispense
If there is less than 12oz of water in
the tank the appliance will not start
and "Tank Empty" will be displayed on
the display. (See Fig. 10)
1 Carafe Dispense
If there is more than 12oz in the tank the appliance will operate with
what water is in the tank.
2
Once the level drops below 12oz, "Tank Empty" will flash on the
display and the appliance will beep once per second for around
1 minute, after which the appliance will stop (it is not possible to
restart and continue the dispense once the appliance has stopped)
3
If water is added while the alarm sounds, the alarm will stop once the
water level increases over the 12oz level; the appliance will continue
to dispense throughout this process.
4 The appliance will not alarm under any circumstance if there is less
than 12oz of water/coffee still to be delivered as the water in the tank
drops below the 12oz mark.
Water Tank Too Hot/Cold
1 If the water in the tank is greater than
86°F the display will show "Too Hot"
and will not operate until the tank
temperature is lowered below this
temperature. (See Fig. 11)
2 If the water in the tank drops below
50°F the brew times will increase.
18
User Interface (Cont.)
Replace Filter
1 The appliance is supplied with an
activated carbon filter to improve the
flavor of the inlet water.
2
The appliance automatically monitors
filter life and once it has expired the
display reads "Replace filter".
(See Fig. 12)
Figure 10
3 Once the filter has been replaced the
counter can be restarted by depressing
the "Water dispense" and "clock/delay
brew" buttons at the same time and
hold for two seconds.
Figure 11
Figure 12
19