MAINTENANCE SCHEDULE
Service Performed
Check Clutch Lever
Operation
Check Dual Handle
Interlock
Check Fasteners
Check Clutch Cable
Adjustments *
Check Tire Pressure
Check Engine Oil
Change Engine Oil **
General Lubrication
* After first use.
** Refer to engine manual for instructions.
SERVICE PARTS
See your Ariens dealer to purchase service
parts for your unit.
Description
Ariens Hi-Temp Grease
• 97 ml (3 oz) cartridges (3)
• 414 ml (14 oz) cartridge (1)
Ariens L3 Lube – 237 ml (8 oz) 00068800
Shear Bolt and Nut
Fuel Stabilizer – 118 ml (4 oz)
Gearcase Seal Washer
20 Watt Headlight Bulb
Spark Plug
Ariens 5W-30 Engine Oil
• 473 ml (16 oz)
• 946 ml (32 oz)
CHECK DUAL HANDLE
INTERLOCK
1. Stop engine.
2. Engage attachment clutch and then the
traction drive clutch.
3. Release the attachment clutch lever. The
attachment clutch should stay engaged
until the traction drive clutch lever is
released.
If dual handle interlock does not operate
correctly, adjust or repair as directed in the
service guide for your unit.
CHECK FASTENERS
Check for loose hardware.
CHECK CLUTCH CABLE
ADJUSTMENTS
•
Auger / impeller must stop within 5 seconds
when attachment clutch lever is released.
•
Wheels must stop quickly when traction drive
•
clutch lever is released.
If clutches do not engage or disengage
•
•
correctly, see Adjust Attachment Clutch &
Brake on page 18 or Adjust Traction Drive
•
Clutch on page 20. Refer to the service guide
•
for your unit for more information about clutch
repairs.
•
•
CHECK TIRE PRESSURE
Keep tires inflated to pressure listed on tire
sidewall.
Part No.
00036800
00036700
52100100
04730400
04742500
(for Canada
Only)
06400920
00432600
CHECK ENGINE OIL
21534100
NOTICE: Engine oil level must be maintained
at correct level or engine damage may occur.
00091000
Refer to engine manual.
00067600
CHANGE ENGINE OIL
Refer to engine manual.
EN - 13
WARNING: AVOID INJURY.
Explosive separation of tire and
rim parts is possible.
• DO NOT inflate tires above
the recommended pressure.
• DO NOT inflate tires with a
compressor; use a hand
pump.
• DO NOT stand in front of tire
assembly when inflating. Use
a clip-on chuck and extension
hose long enough to allow you
to stand to one side.
• DO NOT mount a tire without
proper equipment and
experience.