Mount The Camera - D-Link DCS-2630L User Manual

Section 2: Installation
Refer to the steps below to assist you with mounting the camera. We suggest that you configure the camera before mounting.
1. Rotate the camera base cover counterclockwise, then lift it to expose
the mounting holes.
2. Place the camera base where you want to position the camera and
use a pencil to mark the holes.
3. Depending on the material of the wall or ceiling, use proper tools to
drill four holes 25mm deep with a 6mm drill bit where you marked.
If the wall is made out of concrete, drill the holes first, then insert the
plastic anchors to support the screws.
4. Place the camera base over the holes that are in the wall. Make sure
to align the camera base holes with the holes in the wall. Use the
supplied screws to attach the camera to the surface of the wall.
Note: Do not overtighten the screws as this may crack the mount.
D-Link DCS-2630L User Manual

Mount the Camera

1
2
3
4
12