Network - D-Link DCS-2630L User Manual

Section 4: Configuration
Use this section to configure the network connections for your camera. All relevant information must be entered accurately. After making any changes,
click Save Settings.
Automatic IP Select this option if you have a DHCP server (i.e., router) running
Address: on your network and would like your camera to obtain an IP
address automatically.
Static IP Address: Select this option to manually enter the IP settings on your camera.
IP Address: Enter an IP address for your camera.
Subnet Mask:
Enter the subnet mask for your network. The default value is
255.255.255.0.
Default Gateway: Enter the default gateway address. This is usually the LAN IP
address of your router.
Primary DNS:
Enter the IP address for the primary DNS (domain name server)
that translates names to IP addresses. This is usually the LAN IP
address of your router.
Secondary DNS: The secondary DNS acts as a backup to the primary DNS.
PPPoE:
Select to enable this setting if your network uses PPPoE (Point
to Point Protocol over Ethernet). Select this option only if your
camera is directly connected to your broadband modem.
User Name & Enter the user name and password for your PPPoE account. Re-
Password:
enter your password to verify. You may obtain this information
from your ISP.
PPPoE Status: Displays the status as active or inactive.
D-Link DCS-2630L User Manual

Network

IPv4
25