Install The Bobbin - IKEA SY Instruction Manual

ENGLISH

Install the bobbin

CAUTION: Moving parts.
To reduce the risk of injury,
switch off before servicing.
Close before operating the
machine.
1. Remove the accessories compartment by pulling it leftwards. Then
open the bobbin case by pushing down the latch on the left on the
cover. Pull out the little latch on the bobbin case and pull the bobbin
case straight out of the machine.
2. Install the bobbin into the bobbin case.
3. Pull the thread into the groove in the bobbin case.
4. Now pull the thread under the tension spring and into the opening.
Leave about 15 cm of thread hanging out of the bobbin case. When you
pull the thread, the bobbin should spin clockwise.
5. Install the bobbin case back into the sewing machine, so that the pin
on the case fits into the hole. Close the cover and put the accessories
compartment back into place.
12
1
2
4
3
5