Top Cover Is Open; Prepare For Parts Replacement; Parts Replacement Time Has Passed; Unknown File - Canon iPF685 Series Basic Manual

iPF685 Series
Hardware error. 03130031-2F7x (x is 0, 1, or 2)
Cause
The ink tank is not Turn off the power, remove and then reinstall all of the ink tanks, and then turn on the power.
installed correctly. If the same message is displayed again, write down the error code and message, turn off the printer, and
contact your Canon dealer for assistance. (See "Replacing Ink Tanks.")

Top cover is open.

Top cover is open.
Cause
The printer has detected that the Top Cover is
open.

Prepare for parts replacement.

Prepare for parts replacement.
Cause
It is almost time to replace consumables for
which service is required.

Parts replacement time has passed.

Parts replacement time has passed.
It is past the recommended time to replace consumables for which service is required.

Unknown file.

Unknown file.
Cause
Data sent to keep the printer up to date (such as pa-
per information) is in the wrong format.
You have uploaded firmware for a different model.
Multi-sensor error
Multi-sensor error
Cause
Direct sunlight or strong lighting may be shining on
the printer and causing the sensor to malfunction.
The performance of a sensor inside the printer may
be impaired.

Error in cutter position.

Error in cutter position.
Cause
The Cutter Unit stops in the middle of cutting.
Basic Guide
Open the Top Cover fully, remove any foreign objects, and close the Top Cover
again.
If the error occurs again, close the Top Cover, turn off the printer, and wait a while
before restoring power.
If "Parts replacement time has passed." is displayed, you can continue to use the
printer for some time.
Contact your Canon dealer for assistance.
Cause
Check the data. Turn off the printer and wait a while before restoring power,
and then resend the data.
Check the firmware version. Turn off the printer and wait a while before re-
storing power, and then resend the firmware.
If the message is displayed again, contact your Canon dealer for assis-
tance.
Take steps to ensure the printer is not used when exposed to direct sunlight
or strong lighting.
Turn off the printer and wait at least three seconds before restoring the pow-
er.
If the message is displayed again, contact your Canon dealer for assistance.
Corrective Action
1.
Push the Release Lever back and remove the paper.
2.
Pull the Release Lever forward.
Corrective Action
P.25
➔
Corrective Action
Corrective Action
Contact your Canon dealer for assistance.
Corrective Action
Corrective Action
Top cover is open.
Corrective Action
131