Set-Up & First Brew - Keurig K-Cup K145 Owner's Manual

SECTION 1
You cannot use your Keurig
IMPorTanT:
it has been set-up for its first use as set forth below.
If the brewer has been exposed to
noTe:
temperatures below freezing, allow brewer at
least two hours to reach room temperature
before brewing. A frozen or extremely cold brewer
will not operate.
Setting up Your Brewer
1
fig.
BREW DRAIN
Unwrap cord and plug the brewer into a
1.
grounded outlet. Remove all pieces of
packing tape.
Ensure BREW/DRAIN Selector Knob is set
2.
2
fig.
to BREW (fig. 1).
Place a large mug (10 oz. minimum) on
3.
the Drip Tray Plate.
Remove the Water Reservoir from the brewer
4.
by first removing the Water Reservoir Lid (fig. 2),
then lifting Reservoir straight up and away from
the brewer (may be tight). Rinse with fresh water.
Fill Water Reservoir with bottled or filtered
5.
water. The water level should reach the line just
below the top edge of the clear viewing area.
Do not overfill.
Set-Up & First Brew
brewer until
®
6.
3
fig.
7.
4
fig.
8.
ADD WATER
DESCALE
HEATING
9.
DRAIN BREWER
AUTO-OFF
10.
POWER
BREW
6
Place Water Reservoir base into the left side of
the brewer and be sure the Water Reservoir
Lock Tabs engage with the Lock Tab Slots on
the brewer (fig. 3). Replace Water Reservoir Lid.
Press POWER Button found on upper right
panel of the brewer. The green POWER Light
will illuminate.
NOTE: A K-Cup
®
.
be used for this sequence
NOTE: If the Water Reservoir is empty or not
correctly placed on the brewer, the blue ADD
WATER Light will illuminate. The BREW Button
will not be activated until water is added to the
Water Reservoir and the Water Reservoir
is in place.
The green brew size indicator lights on the LED
Control Center will flash to indicate the brewer
needs to be set-up. Make sure the Handle is
lowered completely before continuing.
Press the flashing blue BREW Button.
The brewer will automatically heat the water.
This will take about 4 minutes. During the
heating period, the red HEATING Light will
illuminate. Once the water is heated, the red
HEATING Light will turn off and the lights
indicating the brew size will illuminate.
NOTE: Do not lift Handle during this heating period.
pack should not