Brewing A Partial Cup; Brewer Shuts Off Automatically; Water Appears In The Brewer Base; Drain Process Notes - Keurig K-Cup K145 Owner's Manual

SECTION 4 Troubleshooting
SITuaTIon SoLuTIon
Blue Add Water Completely remove the Water Reservoir and
•
Light, red Heating thoroughly clean (refer to page 11). Ensure the
Light and Small Water Reservoir is filled. Return it to the brewer and
Mug Button ensure it is seated properly, then press the flashing
are all flashing BREW Button.
simultaneously If you have completed the above procedure two times
•
and the situation persists, contact Customer Service
at 1.866.901.BREW (2739).
Brewing a If the brewer has been set-up without a cleansing
•
partial cup brew, the first cup may be oversized. The next cup
will be brewed to the proper selected size.
The Exit Needle may be clogged (refer to page 11).
•
Clean K-Cup
•
page 10).
A partial drain process may have occurred. The
•
brewer will brew the next cup at the selected size.
The Water Reservoir may have been removed during
•
brewing. Replace the Water Reservoir and perform
a cleansing brew without a K-Cup
If the amber DESCALE Light is illuminated, descale
•
the brewer (refer to page 11).
If you have repeated the descale procedure on
•
your brewer two times and it is still only brewing
a partial cup, contact Customer Service at
1.866.901.BREW (2739).
Pack Holder if necessary (refer to
®
pack.
®
SITuaTIon SoLuTIon
Brewer shuts off Check to make sure that the Auto-Off Timer feature
•
automatically has not been enabled. If the green AUTO-OFF Light is
illuminated, press the black AUTO-OFF Button to
disable the Auto-Off Timer feature.
Water appears in It is normal for a small amount of water (less than
•
the Brewer base 10 ml) to collect if the Water Reservoir is not seated
with the Water for a period of time. This will not affect the operation
Reservoir removed of the brewer.
Use clean cloth or paper towel to absorb the water.
•
Return the Water Reservoir back to the brewer base
•
(refer to page 6, fig. 3).

Drain process notes

BREW/DRAIN Selector Knob turned to DRAIN during
•
a brew cycle: If this occurs, the brewing cycle is
immediately stopped. Recovery: The brew that
immediately follows may provide an improper volume,
so perform a brew without a K-Cup
brew will be of the proper selected size.
BREW/DRAIN Selector Knob turned to DRAIN and
•
back to BREW: The brewer is smart and knows if the
DRAIN Button has been pressed. If it has not been
pressed, and only the knob has been turned to DRAIN
and back to BREW, the brewer does not need to be
set-up again.
BREW/DRAIN Selector Knob turned to DRAIN and
•
DRAIN Button pushed, but tank not emptied. To brew,
set-up the brewer and then perform a cleansing brew
(refer to page 6).
If any problems persist, contact Customer Service at 1.866.901.BREW (2739).
14
pack. The next
®