Secure Heater To Floor Or Hearth - Monessen Hearth DBX24C Installation And Operating Instructions Manual

DFX & DBX Series Vent Free Fireplaces
SECURING HEATER TO FLOOR OR HEARTH
NOTE: Clearance requirements as detailed in "CLEaRanCES and HEiGHt REquiREmEntS"
section on Page 16 of this manual, must be met before securing the heater in place.
To prevent movement, the heater must be secured to the floor or hearth.
1. Open the control access door and remove the screen.
. Remove carton containing the four-log set.
3. To remove the grate and base assembly, take out two () screws as shown in Figure 9.
4. Lift grate and base assembly out of the firebox.
5. Secure the firebox with two anchoring screws (3/16" x 1Z\v" length) supplied with the fireplace
system. Figure 10
NOTE: If the unit is mounted on carpeting, tile or combustible material without the hearth, a metal
or wooden base covering the entire width and depth of the base must be installed.
Screws
Grate
Figure 9 -
Remove Grate
1
FP2515
remove grate
Anchor Screws
3/16" x 1Z\v"
FP515
Figure 10 -

Secure Heater to Floor or Hearth

FIREPLACE INSTALLATION
FP516
FP2516
secure base
33D4047