Table of Contents
Advertisement
NOTE: Clearance requirements as detailed
in "Clearances and Height Requirements"
section of this manual must be met before
securing heater in place.
To prevent movement, the heater must be secured
to the floor or hearth.
1. Open the control access door and remove the
screen.
2. Remove log set.
3. To remove the grate and base assembly, take out
two screws as shown in Figure 16.
4. Lift grate and base assembly out of the firebox.
Lift grate and base assembly
using the grate only.
4. Secure the firebox with two anchoring screws (
1
x 1
/
" length) supplied with the fireplace system.
4
See Figure 17 .
Note: If the unit is mounted on carpeting,
tile or combustible material without the
hearth, a metal or wooden base covering
the entire width and depth of the base must
be installed.
26D3311
3
/
"
16
Figure 16 - Removing Grate and Base Assembly
Figure 17 - Securing Firebox to Floor or Hearth
SECURING HEATER TO FLOOR
15
Hide quick links:
Advertisement
Table of Contents
