LC-13SH1E
LC-15SH1E
9) Finally click [Restart System] to initialize. Confirm "Reset done" in Comment Window.
10) Power OFF the set by unplugging AC Cord, remove the JIG from the plug and wait for 1 minute before
power ON again.
Notes: If any error occur during any process, power OFF the set and repeat the all the process again. If
these still fail, please erase Main Software and repeat the whole process again. To erase Main software,
please refer to MAIN microprocessor step No. 1) to 5) only.
2. MAIN microprocessor
1) Set JIG switch to position "LOC".
2) Power ON the set and plug Interface JIG connector to P2002.
3) Run the WISP.exe program.
18