Logs; Ember Material And Lava Rock Placement; Flame & Temperature Adjustment; Flame Characteristics - MHSC 36CDVXTRN Installation Instructions And Homeowner's Manual

CDVX Series Direct Vent Gas Fireplace
The 36CDVX logs are shipped in place. If a log is
broken, refer to the replacement parts list for a replace-
ment. Figure 63 shows where the logs are secured to
the fireplace.
Figure 63
Lava Rock
Flame & Temperature Adjustment
RN/RP & EN/EP Models
For units equipped with "HI/LO" valves the flame
adjustment is accomplished by rotating the "HI/LO"
adjustment knob located near the center of the gas
control valve. (Figs. 64)
SIT 820 Valve
Turn
counterclockwise
to increase
flame height
Fig. 64 Flame adjustment knob for SIT valve.
FP390
Figure 66
FLAME ADJUSTMENT KNOB
11/21/96
LG481
30

Logs

Turn clockwise
to decrease
flame height
Yellow Flame

Ember Material and Lava Rock Placement

Separate the ember material into small pieces, roughly
1/2" in diameter and place on the front burner tube. Do
NOT pack down, leave in fluffy, loose condition for most
realistic ember effect. (Fig. 62)
The lava rock provided with this fireplace
must be placed on the firebox base
around the burner assembly. (Fig. 63)
Under no circumstances should this lava
rock be placed on any part of the burner.
LG480
Ember Material

Flame Characteristics

It is important to periodically perform a visual check
of the pilot and burner flames. Compare them to the
illustrations. (Figs. 65 & 66)
If the flame patterns appear abnormal contact a
qualified service provider for service and adjustment.
Fig. 65 Correct pilot flame appearance.
Red Glow, Yellow Tips
SIT RN/RP
FP1541
20012253