Table of Contents
Advertisement
Features & Controls
Head-Up Display
(CONT.)
To switch the speedometer from
English (conventional) to metric
units, or back again, use the tip of a
ball point pen (or something similar)
to depress the MODE button on the
Driver Information Center until
ENGLISH or METRIC appears on
the
display. Release the MODE
button and use the pen to depress the
SET
button below it to switch to the
,other unit of measure.
Care of the Head-Up Display
Clean the inside of the windshield as
needed to remove any dirt or film that
reduces the sharpness or clarity of the
HUD image.
To Clean the HUD:
Spray household glass cleaner on a soft,
clean cloth. Wipe the HUD lens gently,
then dry it. Do not spray cleaner
directly on the lens, because the cleaner
fluid could leak inside the unit if you
do.
If You Can't See the HUD Image
When the Ignition is On:
Is anything covering the HUD unit?
Is the HUD dimmer control close
enough to HI?
Is the HUD image adjusted to the
proper height?
Still no HUD image? Check the fuse
in the CLUST position in the fuse
panel. See the
Index
under
Fuses
G
Circuit Breakers.
Advertisement
Table of Contents
