Table of Contents
Advertisement
Bundle the antenna cables using
commercially available cord clips and adjust
the cable lengths.
DAB/DAB+ radio station is not received
properly.
Check all antenna connections, then perform
the DAB Automatic Scan procedure. See
"Running the DAB Automatic Scan manually"
(page 15).
The current DAB/DAB+ service may not be
available. Press / to select a different
service.
If you have moved to another area, some
services/frequencies may have changed and
you may not be able to tune into your usual
broadcast. Perform the DAB Automatic Scan
procedure to re-register the contents of
broadcasts. (Performing this procedure clears
all previously stored presets.)
The DAB/DAB+ broadcast has been
interrupted.
Check the location of the system or adjust the
orientation of the antenna to increase the
indicated value of the signal quality.
Network connection
The system cannot connect to the network.
(Other equipment on the network cannot
find or recognize the system.)
Check that
is lit in the display window.
It takes about 1 minute for the system to
acquire an IP address when the system is
turned on in a communication environment
without a router.
When you use a fixed IP address, the same IP
address may be used by other equipment. Use
a different IP address.
The system cannot connect to the network
via a wireless LAN connection.
If a network (LAN) cable is connected to the
system, the system automatically operates to
establish a wired LAN connection. If you wish
to use a wireless LAN connection, do not
connect a network (LAN) cable to the system.
Check the settings of the wireless LAN router/
access point. If the SSID stealth mode is set to
"On" on the access point, set it to "Off." For
details on the settings of the access point of
the wireless router, refer to the operating
manual for the access point.
The system cannot connect to the network
using WPS.
Set up your network after searching the access
point using the access point scan.
You cannot connect to a network using WPS
when your access point is set to WEP.
Update the firmware of the wireless LAN
router/access point to the latest version.
Music Services
The system cannot connect to Music
Services.
Make sure the wireless LAN router/access
point is turned on.
Check that
appears in the display window.
If not, set up a wireless network again. For
details, see Quick Start Guide.
When the system is connected to a wireless
network, place the wireless LAN/access point
and the system closer together and perform
the setup again.
Depending on the providers, only one
connection to Internet is allowed. In that case,
the system cannot be connected if connection
is occupied. Please consult your carrier or
service provider.
When you turn on your mobile phone
(Android device, Xperia device, or iPhone/iPod
touch) after a moment of power off, try to
restart the "SongPal" application.
Home Network
The controller (the operating device) cannot
find this system. (The controller cannot
browse the contents of this system.)
Make sure that the controller is connected to
the home network.
The multicast control on the access point is
enabled.
Music started automatically.
This system may be controlled by another
component. To reject the control, set the
BLUETOOTH/Network Standby mode to off
(page 31).
The sound is interrupted.
The DLNA server is overloaded. Quit all
running applications.
39
GB
Hide quick links:
Advertisement
Table of Contents
