Usage Instructions - Frigidaire FRT095DBL Instruction Manual

Leveling Your Refrigerator:
After discarding crating screws and wood base, use a carpenter's level to level the
refrigerator from front-to-back. Adjust the plastic leveling feet in front, ½ bubble
higher, so that the door closes easily when left halfway open.
Electrical Installation
Before turning on the refrigerator, check to see if the voltage of the outlet to be
used is the same as that indicated on the tag located close to the plug (along the
power cord) or on the refrigerator's identification label.
Check to see that the refrigerator's plug is not connected on top of the power cord.
Connect the refrigerator to its own outlet. Do not use an extension cord or adaptor
plug.
For your safety, ask an electrician to verify the condition of the electric wiring in the
area where the refrigerator will be installed. The wires leading to the outlet into
which the refrigerator will be plugged should be made of copper and be at least 2.5
2
mm wide.
For greater safety, consult the legislation on electrical installations in your country.
Grounding
The power cord has a three-pronged grounded plug for your personal safety. It
must be connected to a grounding type wall receptacle, in accordance with the
legislation governing electric installations in your country, as well as any local
regulations. Do not remove the grounding prong, do not use a two pronged
adaptor, and never make a connection to the schematic. Use the cord supplied
with the equipment (do not change it). If the cord is damaged, it must be
immediately replaced by specialized personnel.
Attention
For your safety, installation must be grounded. If it is not grounded, it must be
adapted for a specialized personnel.
33

Usage instructions

How to Turn on the Refrigerator
1. Clean the parts of the refrigerator with warm water containing a little neutral
detergent and with clear water, and wipe them dry.
2. Turn the thermostat knob to the "MAX" position, turn on electricity. The
compressor and the light inside the refrigerator begin to work.
3. Open the door 30 minutes later, if the temperature in the refrigerator decreased
obviously, it shows that the refrigerator system works well. When the
refrigerator operates for a period of time, the temperature controller will
automatically set the temperature within limits it opens.
Electric parts of the refrigerator can only be wiped by dry cloth.
Attention
After turning off your unit you need to wait at least 10 minutes to turn it on again.
Filling the Refrigerator
Follow these instructions the first time you fill the refrigerator, or after you defrost
it.
1. Turn the refrigerator on and let it run for two hours prior to putting food inside.
2. If the food is fresh, put it in the refrigerator little by little, with one hour intervals.
3. Load first shelves and then start loading the door compartments.
4. For freezer food storages use one hour intervals between them.
5. After filling the refrigerator, adjust the thermostat to the appropriate position,
following the instructions under item "Temperature Adjustment".
Freezing capacity
The interior of the freezer compartment keeps foods at temperatures of -18 ° C.
34