Introduction & Specifications - Dyna-Glo DELUX User's Manual And Operating Instructions

Dyna-Glo ProPane ForceD air construction Heaters
The heater is designed and approved for use as a construction heater under anS z83.7 CSa 2.14. it is hard
to anticipate every use which may be made of this heater.
AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS.
Other standards govern the use of fuel gases and heat producing products in specific applications.
your local authority can advise you about these.
IMPORTANT: read ThiS uSer'S Manual CareFully and CoMpleTely BeFore Trying
To operaTe or ServiCe ThiS heaTer. iMproper uSe oF ThiS heaTer Can CauSe
SeriouS injury or deaTh FroM Fire, exploSion and CarBon Monoxide poiSoning.
This is a direct-fired forced air construction heater for either indoor construction or outdoor use. Its intended
use is primarily the temporary heating of buildings or structures under construction, alteration or repair. all the
products of combustion generated by the heater are forced through the heater and released into the area being
heated. This heater operates at approximately 98%+ combustion efficiency but still produces a small amount
of carbon monoxide. humans can tolerate small amounts of carbon monoxide for short periods. Carbon
monoxide can build up in a heated space and failure to provide adequate ventilation could result in poisoning
or death.
Model No. RMC‐FA40DGP/
DGP‐01
Input Rating 40,000 BTU/hr
Type of Gas Propane
Gas Supply Pressure to
Cylinder Pressure
Regulator Maximum
Minimum (for purpose of
5psig
Input Adjustment)
Manifold Pressure 11" W.C
1.9lbs/hr
Gas Consumption
Electrical Input 120V, 60Hz, 1Ø
Amperage Load 0.68amps
3550rpm
Unload
Fan
3000rpm
Load
Ignition Piezo/Manual Spark
Spark Gap 0.16" (4mm)
19.3"x8.3"x15.2"
Size (LxWxH)
(490x211x386)mm
13.7lbs/14lbs
Weight
(6.2kg/6.35kg)
3
PROPANE CONSTRUCTION HEATER
WARNING
: noT For uSe wiTh duCT work.
sPeciFications
FA50 Series FA60 Series
30,000 BTU/hr 30,000 BTU/hr
50,000 BTU/hr 60,000 BTU/hr
Propane Propane
Cylinder Pressure Cylinder Pressure
5psig 5psig
11" W.C 11" W.C
1.4lbs/hr 1.4lbs/hr
2.3lbs/hr 2.8lbs/hr
120V, 60Hz, 1Ø 120V, 60Hz, 1Ø
0.65amps 0.65amps
3570rpm 3570rpm
3300rpm 3300rpm
Continuous Spark Continuous Spark
0.16" (4mm) 0.16" (4mm)
19.3"x8.3"x15.2" 19.3"x8.3"x15.2"
(490x211x386)mm (490x211x386)mm
14.3lbs (6.48kg) 14.3lbs (6.48kg)
CHECK WITH YOUR LOCAL FIRE SAFETY
RMC‐FA100DGD/ LPFA125DGD/
DGP/DGP‐01 RMC‐FA125DGP/
DGP‐01
70,000 BTU/hr 70,000 BTU/hr
100,000 BTU/hr 125,000 BTU/hr
Propane Propane
Cylinder Pressure Cylinder Pressure
5psig 5psig
11" W.C 11" W.C
3.3lbs/hr 3.3lbs/hr
4.6lbs/hr 5.8lbs/hr
120V, 60Hz, 1Ø 120V, 60Hz, 1Ø
0.7amps 0.7amps
3580rpm 3580rpm
3300rpm 3300rpm
Continuous Spark Continuous Spark
0.16" (4mm) 0.16" (4mm)
25.6"x12.7"x15.6" 26.6"x13.0"x17.3"
(650x323x396)mm (676x330x439)mm
25.6"x11.8"x16.1" 25.6"x11.8"x16.1"
(650x300x409)mm (650x300x409)mm
21.5lbs/21lbs/20.8lbs 21.9lbs/21lbs/20.8lbs
(9.75kg/9.5kg/9.4kg)
(9.9kg/9.5kg/9.4kg)
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
LPFA125H/ RMC‐FA150DGD
RMC‐FA125DGD
70,000 BTU/hr 120,000 BTU/hr
125,000 BTU/hr 150,000 BTU/hr
Propane Propane
Cylinder Pressure Cylinder Pressure
5psig 5psig
11" W.C 11" W.C
3.3lbs/hr 5.6lbs/hr
5.8lbs/hr 7.0lbs/hr
120V, 60Hz, 1Ø 120V, 60Hz, 1Ø
0.7amps 0.7amps
3580rpm 3580rpm
3300rpm 3300rpm
Continuous Spark Continuous Spark
0.16" (4mm) 0.11" (2.8mm)
26.2"x11.5"x17.2"
(666x292x436)mm 25.6"x11.8"x16.1"
25.6"x12.7"x15.6" (650x300x409)mm
(650x323x396)mm
20.3lbs/21.5lbs
21.2lbs (9.6kg)
(21.9kg/9.75kg)