EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension cable)
as shown below.
• Connect the MAIN board (CNP350) and the SERVO board (CN2)
with the extension cable (Part No. J-2502-076-1).
NOTE FOR REPLACEMENT OF THE SERVO BOARD
When repairing, the complete SERVO board (A-1177-362-A) should
be replaced since any parts in the SERVO board cannot be repaired.
NOTE FOR REPAIRING THE FRONT PANEL
The front panel should never be disassembled since it is waterproof
Replace the front panel overall assembly completely when replacing
the key board or other components of the front panel.