System Setting - Sanyo FWDP175F Owner's Manual

A

System Setting

You can change the Display functions. Follow steps 1 and 2 on page 16.
3
Select the desired item.
<SYSTEM menu>
TV Aspect 4:3 Pan & Scan
SYSTEM
Resolution 4:3 Letterbox
LANGUAGE
HDMI CEC 16:9 Widescreen
16:9 Squeeze
AUDIO
VIDEO
OTHER
ENTER
Note:
HDMI CEC:
• HDMI CEC allows integrated system control over HDMI and is part of the HDMI standard.
This function may not work properly depending on the device connected to the unit.
When "HDMI CEC" setting is set to "On" the functions listed below will be available.
▪ One Touch Play
When the buttons below on the remote control are pressed then operations are performed on this unit, the TV will
automatically be turned on and switched to the appropriate video input.
Buttons for one touch play:
- [PLAY B] [SKIP H , G]
,
- [TOP MENU] [MENU]
, or
▪ One Touch Standby
When you press and hold
When the connected fun-Link (HDMI CEC) compatible display device is turned off first, it then turns off the power to this
unit.
▪ System Information
Get & Set Menu Language
The unit recognizes the OSD language set on the TV and automatically sets the same language as the on-screen language in
"Menu" setting.
Feature is available only when "Menu" in "LANGUAGE" menu is set to "Auto" while connected via an HDMI cable.
EN
4
TV Aspect: (Default: 16:9 Widescreen)
Sets the aspect ratio of the playback image to fit your TV.
See the note on the right.
TV Aspect 4:3 Pan & Scan
Resolution 4:3 Letterbox
HDMI CEC 16:9 Widescreen
16:9 Squeeze
Resolution: (Default: Auto)
You can select the desired "Resolution" among the
settings.
See the note on the right.
TV Aspect Auto
Resolution 480P
HDMI CEC 720P
1080i
1080P
HDMI CEC: (Default: Off)
HDMI CEC allows integrated system control over HDMI.
See the note below.
TV Aspect On
Resolution Off
HDMI CEC
[DISPLAY] [SETUP]
, ,
(when a disc is inserted in the unit)
[STANDBY-ON]
for 2 seconds, it turns off the TV first and then turns off this unit.
Select the Desired
Setting.
– 17 –
5
To Exit the Menu
Note(s):
TV Aspect:
• Select "4:3 Pan & Scan"
for a full height picture
with both sides adjusted.
• Select "4:3 Letterbox",
black bars may appear on
the top and bottom of the
TV screen.
• Select "16:9 Widescreen"
if a wide-screen TV is
connected to this unit.
• Select "16:9 Squeeze"
to display 4:3 aspect ratio
in the center of the 16:9
screen when playing back
4:3 images.
Resolution:
– Auto:
HDMI video resolution
will be selected
automatically depending
on the connected HDMI
device.
• When you make a
selection, the TV monitor
temporarily goes blank
and then comes back
again. If it does not, press
and hold
[ BF (PLAY /
on the front
PAUSE) ]
panel for 5 seconds to
change the setting of
the resolution back to its
default.