U-Line 95 Icemaker Service And Parts Manual page 26

Service and Parts Manual
6. Low ice production
Cause
Control set too cold
Fan motor stalled
Ice cubes too large
Dirty condenser
Bypass valve stuck open
7. Not freezing (compressor and fan motors operating)
Cause
Little or no frost pattern on evaporator
restriction
Bypass valve stuck open
8. Not freezing (compressor not operating - fans operating)
Cause
Relay defective
Overload defective (open)
Compressor defective
9. Not freezing (compressor and fans not operating)
Cause
On-Off switch defective (open)
Hold switch defective (open)
Control defective (2-3 contacts open)
Broken wire in freeze circuit
Power cord not plugged in
On-Off switch in off position
Ejector blades not in the freeze
position (12:00)
10. Compressor overheating
Cause
Condenser air flow restricted
Condenser fan blade obstructed
Condenser fan motor stalled
Defective compressor
11. Compressor will not stop operating
Cause
Control set too cold
Control defective (2-3 contacts will not
open)
Control sensing bulb not sensing
mold temperature
Evaporator fan stalled
12. Water leak (under unit)
Cause
Water supply line leaking at solenoid
valve inlet
Remedy
Adjust control warmer (counterclockwise)
Replace fan motor
Lower water fill adjustment
Clean condenser
Remedy
Remedy
Replace relay
Remedy
12:00 position (test ice maker and
limit switch)
Remedy
and grille)
Remedy
Adjust control warmer (counterclockwise)
routing bulb away from compressor
discharge tube
Remedy
Replace bypass valve
Check for sealed system leak or
Replace bypass valve
Replace overload
Replace compressor
Replace On-Off switch
Replace hold switch
Replace control
Repair or replace wiring
Plug in power cord
Put switch in on position
Manually advance ejector blades to the
Remove restriction (clean condenser
Remove blade restriction
Replace fan motor
Replace compressor
Replace control
Fully insert bulb into ice maker tube,
Remove obstruction or replace motor
Tighten or replace fitting
26