75R, 75WC and 75BEV Models 2 Inspect and Plan You have received a carton containing your 75R Refrigerator, 75WC Wine Captain Center with a package inside containing a User Manual and a Product Registration Card. Complete and mail the Product Registration Card or register online at www.U-LineService.com.
75R, 75WC and 75BEV Models 3 Prepare Site Your U-Line product has been designed for either free- standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for electrical connection in the rear.
Product Dimensions 23-7/16" 24" Including Including Handle Handle 34-1/8" 23-15/16" Black and White Refrigerator 75R ® Black Wine Captain 75WC Stainless Wine Captain 25-7/16" Including Handle 23-15/16" Beverage Center 75BEV Figure 2 Please note that the unit has adjustable feet that can add one additional inch to height during leveling or to match adjacent cabinets (see Figure 20 on Page 11).
Note: The grille should not yet be installed. If it has been installed, remove it for door reversing. See Page 11. To reverse the door on Black or White 75R Refrigerator models: 1. Remove top hinge from cabinet (four screws). See Figure 4.
For a complete refreshment center, install two of the following 75 series units side by side: 75R, 75WC and CO75 Combo Ice Maker/Refrigerator. Note that each Side-By- Side Installation will be different. • Cut-out width for a side-by-side installation is the total of the widths listed under Cut-Out Dimensions in each unit’s Installation Guide.
If none of these treatments are to be included in this installation, go on to 5 Adjust Door. Custom 1/4'' Thick Door Panel Insert (75R Refrigerator Units Only) Door Panel Preparation A custom door panel can be inserted into the doorframe.
CAUTION To prevent permanent damage to the inner liner of the Beverage Center, the wine rack wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the stain/finish manufacturer’s instructions prior to re-installing the wood trim inside the cabinet of the Beverage Center.
5 Adjust Door Checking Door Alignment The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation. IMPORTANT Properly aligned, the door's gasket should be firmly in contact with the cabinet all the way around the door (no gaps).
7 Level the Unit Leveling Information Note: It is recommended that the unit is level. 1. Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (see Figure 19).
5. Insert the screw. Do not overtighten. 6. Reinstall control knob. Glass Shelf Installation (75R Refrigerator and 75BEV Beverage Centers Only) 1. Carefully remove the glass shelves from the packaging. 2. Slide the shelves onto lower sets of ribs, making sure the decorative graphics are on the underside of the shelves.
For more than four decades, U-Line has distinguished itself as the leader in built-in undercounter ice making, refrigeration and wine storage appliances. U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in undercounter icemakers, Combo ®...