Advertisement
How to Use Your Vax
Fully extend the mains cable but not
beyond the yellow mark and plug it into
a standard domestic outlet.
Set the power control button to min.
position.
7
Fig.7 Press the foot pedal to start the vacuum
cleaner. Slide the power control button
to the desired setting. To stop it press
the foot pedal again.
Cord Rewind
8
Fig.8 Press the foot pedal to recoil the power
lead. To rewind the power cord,
press the cord rewind button and
with one hand guide the power
cord through palm. Rewind 1-1
metres of cord at a time. This will
prevent the cord from whipping,
which could cause damage or
injury.
4
9
Fig.9 The hose grip has an air regulator
which allows further control of suction
power. To reduce suction power, slide
regulator to open position.
10
Fig.10 If you wish to pause briefly during
vacuuming i.e. to move a piece of
furniture or a rug, use the special
parking position on your vacuum
cleaner as shown. Slide the hook
attached to the large cleaning tool into
the slot on the rear of the appliance.
/
1
2
11
12
Fig.11 & 12 You can move or store your
appliance in a vertical position
by sliding the hook on extension
tube into the clip on the
underside of the appliance. This
practical system allows you to
carry the vacuum cleaner around
in one hand and to store it in the
minimum of space.
Caring For Your Vax
Your appliance is equipped with a dust bag.
If you notice that the vacuum cleaner seems
to be less efficient that usual, check the dust
indicator by selecting the maximum power
and lifting the cleaner tool off the floor. If it
turns red, empty or change the dust bag.
To Empty the Dust Bag
13
Fig.13 Turn off the appliance and unplug it.
Lift up the catch to raise the cover
and gain access to the dust bag
compartment. Remove the bag by
pulling free of the holder.
14
14
a
Fig.14a The clip on the bag can then be
removed as shown.
Fig.14
Shake the dust bag over a bin so
that the dirt can be removed. Once
empty, replace clip and re-assemble
in cleaner.
If a disposable bag is used, simply remove
and replace with a new bag.
Changing the Filters
15
Motor Protection Filter
Fig.15 This filter protects the motor from
dust and is located in the dust bag
compartment.
To replace filter, remove the filter grill,
remove the motor protection filter and
reinstall with a new motor protection
filter along with the existing filter grill.
We recommend changing this filter
after 5 bag changes or when the filter
appears soiled.
5
Advertisement
