Related Manuals for Vax VS-033
Summary of Contents for Vax VS-033
- Page 1 VS-033 easy guide Please read carefully before using your VS-033. Always fully extend mains cable before use.
- Page 2 Important information - Save these instructions Congratulations on the purchase of your VS-033 cylinder cleaner. In order to get the best performance from this product please read and retain these instructions. When using electrical appliances, in order to reduce the risk of fire, electric shock, and/or injury to persons, basic safety precautions should be followed, including the following: •...
- Page 3 How to use your VS-033 Assembling the appliance fig. 1 The telescopic extension tubes can be lengthened by pressing the button & pulling the tubes apart. fig. 2 To attach the flexible hose to the vacuum cleaner, push the connecting end of the flexible hose into the...
- Page 4 How to use your VS-033 Adjusting the cleaning tool for carpets & hard floors fig. 3 Hard floor position (tiles, parquet floors, etc.) – The cleaning tool’s brush must be in the lower position. Press on the rocker switch to lower it.
- Page 5 How to use your VS-033 Fully extend the mains cable and plug it into a standard domestic outlet. fig. 5 Press the foot pedal to start the vacuum cleaner. To stop it press the pedal again. fig. 6 Press the foot pedal to recoil the power lead.
- Page 6 BAG FULL How to use your VS-033 fig. 8 Vacuum power can be adjusted electronically by moving the variable power control. Using the accessories fig. 9 Open the accessory storage compartment (fig. 9a). These accessories can be fitted onto the tubes or directly onto the end of the flexible hose handle.
- Page 7 How to use your VS-033 fig. 10 If you wish to pause briefly during vacuuming i.e. to move a piece of furniture or a rug, use the special parking position on your vacuum cleaner. Slide the hook attached to the large cleaning tool into the slot on the rear of the appliance.
- Page 8 How to care for your VS-033 Your appliance is equipped with a dust bag. If you notice that the vacuum cleaner seems to be less efficient than usual, check the dust indicator by selecting the maximum power and lifting the cleaner tool off the floor. If it turns red, change the bag.
- Page 9 To change the filters Motor protection filter fig. 15 The filter is located in the dust bag compartment and protects the motor from dust. To reach this filter, lift up the grill which secures it and replace it with a new one. We recommend changing the filter after 5 bag changes or when it appears soiled.
- Page 10 To clean and dry the filters Motor protection filter fig. 15 The filter is located in the dust bag compartment and protects the motor from dust. To reach this filter, lift up the grill which secures it and replace it with a new one. We recommend changing the filter after 5 bag changes or when it appears soiled.
-
Page 11: Replacement Parts
Check carefully which of these causes is making the light go on and correct it so that the vacuum cleaner can work normally. Do not work with the vacuum cleaner with this indicator light on, for this could cause irreparable damage to the motor. Replacement parts Replacement parts VS-033 – 5 bags Part Number 1-9-124757-00 VS-033 Filter Pack Part Number 1-9-124813-00... - Page 12 If you have queries or concerns about using your VAX, call the HELPLINE. Calls are charged at the UK national rate. Please make a note of the serial number and model number of your VAX before calling. VAX Limited, Kingswood Road, Hampton Lovett, Droitwich, Worcestershire WR9 0QH, UK Email: enquiry@vax.co.uk - Website: www.vax.co.uk...