Return the vacuum cleaner to only and not for commercial or industrial use. 2. Place foot onto vacuum cleaner head and at the same a Vax Authorised Service Agent or suitably time tilt the vacuum cleaner back to start vacuuming PLEASE...
Allow the vacuum cleaner to cool for approximately one hour. To restart, plug into a wall outlet and switch back on. If the vacuum cleaner still 4. Attach the accessory (Fig.5/4). does not start, contact Vax Care on 0870 6061248. 5. Accessories Fig.6/1 Fig.5/8 NOTE: The two accessory parts may be used on the stretch hose tube and/or the stretch hose.
Page 5
(Fig.7/1). IMPORTANT: Switch off the vacuum cleaner and unplug from the wall outlet. NOTE: Vax recommend changing the post-motor filter every 12 months. Call Vax Care on 0870 6061248 or visit www.vax.co.uk for further information. 1. Remove the dirt container.
Vax VX1 V2 D1 JN.qxd 5/17/05 4:24 PM Page 10 Rotating Brushbar: Removal & Replacement/Maintenance Maintenance 4. Replace the channel cover before attaching the 4. After removing the hose use a feather duster to 2. There is an automatic system which cuts off the hose collar by turning it in an anti-clockwise brush it clean and remove the blockage (Fig.8/8).
There are Weight: 8.4kg Solution: Check fuse or breaker. over 400 approved Vax Service Agents in the UK. For the nearest Service Agent, please call the Vax Careline. Cause: On/off switch not turned on. Subject to technical change without notice.
Page 8
Vax VX1 V2 D1 JN.qxd 5/17/05 4:24 PM Page 14 This page has been intentionally left blank. This page has been intentionally left blank.
Page 9
4:24 PM Page 16 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the declare that the product VX1 is manufactured in compliance with the following: Safety: 73/23/EEC Low Voltage Directive, as modified by 93/68/EEC EMC: 89/336/EEC Electromagnetic Compatibility Directive, as modified by 93/68/EEC Waste electrical products should not be disposed of with household waste.
Need help?
Do you have a question about the VX1 and is the answer not in the manual?
Questions and answers