Advertisement
HEPA Filter
Fig.16 The HEPA filter is also housed in the
dust bag compartment above and
behind the motor protection filter as
shown in fig.16. Remove dirty filter
assembly from machine and dispose
of filter medium. Replace with new
filter medium. Return filter assembly to
your VS-022.
We recommend replacing the air outlet filters
every 4-6 months; after the bag has been
emptied 5 times; when appearance is soiled;
or a loss of suction is experienced (whichever
is sooner).
ATTENTION: Do not use the vacuum cleaner
without all filters installed.
Dust Bag Indicator
17
Fig.17 When the indicator turns red or
when the suction power reduces
substantially, you should empty or
replace the dust bag.
6
18
Fig.18 When the bag is not full the indicator
will show blue.
ATTENTION: If after emptying the dust bag,
the indicator stays red, this could be for
several reasons:
• Suction passages may be blocked -
check flexible hose and extension tubes,
suction inlet, floor brushes and nozzles for
obstruction.
• Check motor protection filter
• Check to see if air outlet filter is dirty
Check carefully for the cause and correct
so that the vacuum cleaner can function
normally.
Do not operate the vacuum cleaner with
the indicator on red, as this could cause
irreparable motor damage.
Assembling Your Vax
1
Fig.1 The telescopic extension tubes can be
lengthened by pressing the button &
pulling the tubes apart.
Attach the required cleaning tool to the
extension tube.
2
Fig.2 To attach the flexible hose to the
vacuum cleaner, push the connecting
end of the flexible hose into the
attachment point on the vacuum
cleaner.
Connect the extension tube to the
flexible suction hose.
Your VS-022 has been
3
equipped with an easy
access storage system.
To
assemble,
follow
instructions:
Fig.3 The tool storage
system
fixing
bracket is already
in place on the
extension
tube.
Insert the holding
tubes as shown
until the tubes
click into place.
4
Fig.4 Place the dusting brush (A) upholstery
brush (B) and crevice tool (C) on the
tubes as shown.
Carpet and Hard Floor
Cleaning Tool
5
Fig.5 Hard floor position (tiles, vinyl, parquet
floors, etc.) - The cleaning tool brush
must be in the lower position. Press on
the rocker switch to lower it.
6
Fig.6 Carpet or rug position - The cleaning
tool brush should be raised. Press the
rocker switch to retract the brush.
3
Advertisement
