Removing And Reinstalling The Main Parts - Sharp CD-BA200 Service Manual

CD-BA200

REMOVING AND REINSTALLING THE MAIN PARTS

TAPE MECHANISM SECTION
Perform steps 1 to 7 and 9 of the disassembly method to
remove the tape mechanism.
How to remove the record/playback and erase
heads (TAPE 2) (See Fig. 10-1)
1. When you remove the screw (A1) x 2 pcs., the recording/
playback head and three-dimensional head of the erasing
head can be removesd.
How to remove the playback head (TAPE 1)
(See Fig. 10-2)
1. When you remove the screw (B1) x 2 pcs., the playback
head.
How to remove the pinch roller (TAPE 1/2)
(See Fig. 10-3)
1. Carefully push the inside claw to remove it. The pinch roller
pawl in the direction of the arrow <A>, and remove the pinch
roller (C1) upwards.
Note:
When installing the pinch roller, pay attention to the spring
mounting position.
How to remove the belt (TAPE 1) (See Fig. 10-4)
1. Remove the main belt (D1) x 1 pc., from the motor side.
2. Remove the FF/REW belt (D2) x 1 pc.
How to remove the belt (TAPE 2) (See Fig. 10-4)
1. Remove the main belt (E1) x 1 pc., from the motor side.
2. Remove the FF/REW belt (E2) x 1 pc.
How to remove the motor (See Fig. 10-5)
1. Remove the screws (F1) x 2 pcs., to remove the motor.
(F1) x2
Ø2.6x5mm
Figure 10-5
Erase Head
STEP2
Pinch Roller
(C1)x1
Motor
FF/REW
TAPE2
Belt
(E2)x1
Main Belt
– 10 –
TAPE2
Record/Playback
Head
(A1)x2
Ø2x9mm
Figure 10-1
TAPE1
Playback
Head
(B1)x2
Ø2x9mm
Figure 10-2
STEP1
<A>
Figure 10-3
Motor
Motor
TAPE2
Main Belt
(E1)x1
Figure 10-4
TAPE1
Main Belt
(D1)x1
TAPE1
FF/REW
Belt
(D2)x1