Restoring A Configuration (Settings Tab) - D-Link DSN-1100 X Stack User Manual

5. Click the Open button.
The configuration file is saved.
6. Record the information in Table C-7.

5.2.4 Restoring a Configuration (Settings Tab)

If you used the procedure in section 5.2.3 to save the xStack Storage configuration, you can
use the following procedure to restore the configuration.
1. In the System Administration View, click the Settings tab to display the general settings
in Figure 5-6 on page 75. Or if you are already in the Settings tab but another screen is
displayed, click the General button on the left side of the Settings tab:
2. Under xStack Configuration, click the Restore button.
The Open dialog box appears (see Figure 5-7 on page 75).
3. Using the Open dialog box, go to the location where you stored the configuration file.
4. Click the file and click the Open button.
The precautionary message in Figure 5-8 appears.
5. Click OK to restore the configuration and reboot the xStack Storage system, or click
Cancel to keep the current configuration and not reboot the xStack Storage system.
76 Chapter 5 System Administration
When naming the configuration file, assign a name that will make it easy to
differentiate this file from other configuration files. For example, you can
use the current date and time or a particular configuration as part of the file
name.
We recommend you write the name and location of the configuration file in
case you need to use it to restore your xStack Storage's configuration.
If you recorded the name and location of the configuration file in Table C-7,
refer to this table for reference
Figure 5-8.Precautionary Message