Installing The Microphone; Installing The Iso Cable - Parrot Asteroid Smart User Manual

Installing the microphone

The optimum location for the microphone is in the centre of the vehicles roof near the rear
view mirror. The microphone ideally needs to be less than 60cm's from the users mouth
pointing directly towards them with no obstructions.
Please take care when routing the microphone cable through the vehicle to the desired
location, we recommend routing alongside existing manufacture's wiring looms securing
as you go making sure the microphone cable is not pinched or trapped.
Warning: Do not run the microphone cable in such a way as to obstruct or interfere with the
vehicles operation or cause injury to its occupants. In particular vehicle safety device such
as airbags and other SRS systems.

Installing the ISO cable

Connect the audio and power connectors of the Parrot ASTEROID Smart to the ones of your
vehicle.
Once the connections are made, check your installation. To do so, turn the ignition on then
off. The "Goodbye" message must be displayed. If it is not the case, it is necessary to swap
the positions of the red and yellow wires. Indeed, the red wire of the power cable must be
connected to the 12V ignition, the yellow wire to the permanent 12V and the black wire to
the ground. This can be done simply by reversing both bullet connectors located on the
Parrot wiring.
Installation 13