Hitachi DZ-MV230A Service Manual page 63

5) When the light amount check complete screen appears, press any key
(except for Esc key) on PC. (*5)
6) The screen for shutter being adjusted (*5) will appear, and then the
shutter adjustment complete screen will appear. Press any key on PC to
restore the shutter adjustment menu screen. (*9)
- Shutter Adjustment No. 2 -
7) Input 2 to PC on the shutter adjustment menu screen to select Shutter
Adjustment No. 2. (*1)
8) The initial setting screen will appear, and the zoom and focus will
automatically be set as follows: (*2)
Digital zoom: Off
Optical zoom: Tele-end
Focus: Close-up end
9) The light amount instruction screen B or D will appear: adjust the amount
of light referring to Table 6-1 until the light amount check complete
screen appears. (*3)(*4)
10) When the light amount check complete screen appears, press any key
(except for Esc key) on PC. (*5)
11) The screen for shutter being adjusted (*5) will appear, and then the
shutter adjustment complete screen will appear. Press any key on PC to
restore the shutter adjustment menu screen. (*9)
12) Press the Esc key while the shutter adjustment menu screen is displayed
to restore the main menu screen (other adjustments can then be done).
(*6)
*1: Pressing the Esc key on the shutter adjustment menu screen will restore
the main menu screen.
*2: Do not operate zoom or focus.
*3: The DVD video camera/recorder will always detect the amount of light
during this adjustment: When the appropriate light amount is detected,
the light amount check complete screen will appear automatically.
In some cases, the light amount check complete screen may appear
without the light amount instruction screen displayed.
*4: If the Esc key is pressed to restore the shutter adjustment menu screen
and adjustment is started again, the light amount check complete screen
may appear.
*5: Pressing the Esc key will restore the shutter adjustment menu screen.
*6: When the DVD video camera/recorder is turned on again, the MAP may
not operate normally, and the subsequent adjustments may not be
possible. If this happens, press the Esc key to restore the MS-DOS
screen, restart the MAP, and then perform any other adjustment (this
adjustment is complete).
*7: ND filters reduce the amount of light entering the lens: The larger the
number, the greater the effect. Overlapping multiple filters will intensify
the effect.
*8: Ordinary incandescent lamp can also be used.
*9: When the shutter adjustment menu screen is restored, the DVD video
camera/recorder will automatically be restarted.
<Continued from preceding page>
Light amount check complete screen
SHUTTER ADJUSTMENT No.
NOW CHECKING LIGHT CONDITION.
LIGHT CONDITION IS GOOD.
Press any key.
Press any key on PC
Screen for shutter being adjusted
SHUTTER ADJUSTMENT No.
NOW ADJUSTING
Please wait a moment.
Shutter adjustment complete screen
SHUTTER ADJUSTMENT No.
COMPLETED
Press any key.
Press any key on PC
Shutter Adjustment
After completing
No. 1 and 2 complete
Shutter Adjustment
No. 1, perform No. 2.
The DVD video camera/recorder will
automatically be turned on, and the
shutter adjustment menu screen will
appear: Press the Esc key to restore the
main menu screen. (Continuing other
adjustments will then be possible.) (*6)
3 - 17