Installing the anchor bolts
1. Unscrew and remove each cover cap.
2. Pull the bolt out until the tip is level
with the tip of the sleeve.
Have another person hold the top of the
drum.
Same level
3. Insert each anchor bolt.
4. Tighten each bolt so that the spring
extends out to the length of 26 mm.
NA-140_148VS4_AUNZ_EN_20140213.indb
26 mm
35
Moving and Installing
Levelling the appliance
Using a level enables ease in adjustments.
To adjust the stands, use the 'A' end of the
spanner.
1. Loosen the lock nut on each stand by
turning it clockwise.
2. Adjust each stand by turning it
clockwise or anticlockwise.
3. Use a spirit level to make sure that
the appliance is properly levelled.
4. Tighten each lock nut by turning it
anticlockwise.
CAUTION
Make sure that all lock nuts are
tightened securely and the stands
are still securely bolted to the
appliance.
If they are unbolted, the appliance will
move around.
Installation Instructions - 35
Lock nut
Stand
2014/02/13
13:35:42