Moving And Installing; Removing The Anchor Bolts; Moving The Appliance - Panasonic NA-140VS4 Operating Instructions & Installation Instructions

Moving and Installing

Removing the anchor bolts

Four anchor bolts keep the interior of the
appliance in place while the appliance
is being moved. Remove them before
installation, using the spanner supplied
with the appliance. Follow the instructions
below.
NOTE
The anchor bolts must be removed
before the appliance is operated.
They may cause excessive vibration.
1. Use the 'B' end of the spanner to
loosen the four bolts.
2. Pull the bolts out horizontally.
34 - Installation Instructions
NA-140_148VS4_AUNZ_EN_20140213.indb 34
3. Remove the screws adjacent to the
bolt holes.
4. Attach each cover cap (included
with the accessories) over each bolt
hole, and then secure them with the
screws removed in step 3.
NOTE
- Make sure that you store the anchor
bolts because they are used when
transporting the appliance. If the
appliance is passed on to another
person, make sure to give the anchor
bolts to that person.
- Make sure the bolt caps are
attached. Failure to observe this may
result in water entering the washing
machine, leading to malfunctions.

Moving the appliance

NOTE
Make sure to install the anchor bolts in
the appliance.
Before you move the appliance
- Shut the tap and run the appliance to
drain the water. Drain remaining water
from the pump hose. (See page 25.)
- Depressurize and remove the water
supply hose.
- Disconnect the power cable.
- Install the anchor bolts. (See page 35.)
2014/02/13 13:35:41