Table of Contents
Advertisement
Removing the anchor bolts
The internal parts are fixed by 4 anchor
bolts. Carry or move the appliance with the
anchor bolts for transport installed, and be
sure to remove the bolts using a spanner
(non-attached article), etc. before setup.
The removed anchor bolts for transport
are quite necessary for moving. Be sure
to hand them over to the customer.
For carrying again, install the bolts
in an order contrary to the removing
order.
Levelling the appliance
- When four feet are on a floor surface, the
appliance must be level and stable without
shaking.
- Level the appliance by using a spirit level
and adjusting the foot height. (Place the
spirit level in the front-rear direction and in
left-right direction.)
- Loosen nut A using a thin spanner.
- Adjust the height of feet B (4 places) by
turning in the direction shown in the figure.
- Tighten nut A upwards to prevent the feet
from loosening.
※The spirit level and spanner are not
supplied as accessories.
CAUTION
If spin-drying operation is conducted
with the bolts for transport installed,
extreme vibration will occur.
Screw
Upper
part
(Do not remove these two screws)
Screw
Lower
part
(Do not remove these two screws)
1 Loosen the anchor bolts (4 pieces) for transport
using a spanner, etc.
2 Pull the rub part of each bolt outwards while
turning it anticlockwise.
3 Take cover caps (4 pieces) from the
accessories, align them with and press them
into the corresponding holes until full matching.
CAUTION
• If the cover caps are not installed properly,
intrusion of foreign matter or entry of an
infant's finger may occur.
• Rubber may be deformed to cause pull-out
difficulty; please contact a service agent.
Spirit level
Installation Instructions - 11
Installation
Spirit level
A
Adjust
B
high
Adjust low
Hide quick links:
Advertisement
Table of Contents
