Table of Contents
Advertisement
Removing the anchor bolts
Four anchor bolts keep the interior of the
appliance in place while the appliance
is being moved. Remove them before
installation, using a spanner. Follow the
instructions below.
Note
The anchor bolts must be removed
before the appliance is operated.
They may cause excessive vibration.
1.
Use a spanner to loosen the four
bolts.
Rotate the bolts anti-clockwise.
2.
Pull the bolts out horizontally.
NA-106VC6_English_WHK.indb 35
Moving and Installing
3.
Attach each cover cap (included with
the accessories) over each bolt hole.
Note
-
Make sure that you store the anchor
bolts because they are used when
transporting the appliance. If the
appliance is passed on to another
person, make sure to give the anchor
bolts to that person.
-
Make sure the cover caps are
attached. Failure to observe this may
result in water entering the washing
machine, leading to malfunctions.
Moving the appliance
Note
Make sure to install the anchor bolts in
the appliance.
Before you move the appliance
-
Shut the tap and run the appliance to
drain the water. Drain remaining water
from the drain filter. (P.27)
-
Depressurize and remove the water
supply hose.
-
Disconnect the power cable.
-
Install the anchor bolts. (P.36)
Installation Instructions - 35
2018-8-1 14:07:50
Advertisement
Table of Contents
