Table of Contents
Advertisement
BI
Hardware Installation
1.
Box Camera Construction
T h e s t a n d a r d t y p e i s C S -
mount lens. If you use C-mount
lens, please apply the CS-C
conversion ring.
2.
Connector Instruction
The back panel of camera is as below. Plug in the power adaptor, and connect
the IP camera to PC or network. Set up the network configurations according
to the network environment. About I/O setting, please refer to chapter VII in
User Manual:
3.
PoE (Power Over Ethernet)(Optional)
Power over Ethernet (PoE) is a technology that integrates power into a
standard LAN infrastructure. It enables power to be provided to the network
device, such as an IP phone or a network camera, using the same cable as
that used for network connection. It eliminates the need for power outlets at
the camera locations and enables easier application of uninterruptible power
supplies (UPS) to ensure 24 hours a day, 7 days a week operation.
"I/O
Configuration" for detail.
8
802.3at, 30.0W PoE Switch is recommended
Advertisement
Table of Contents
