TM
Vanguard
Twin-Cylinder OHV Liquid-Cooled Engine
Section 5 - Engine Assembly
INSTALL RADIATOR
1. Install fan shroud assembly, Fig. 172. Torque
screws to
140 in. lbs. (16. 0 Nm)
mm) gap between the shroud and the radiator to
prevent wear from vibration.
Fig. 172
2. Install radiator, Fig. 173. Torque nuts with
washers to
100 in. lbs. (11. 0 Nm)
mounting nuts first, then upper mounting nuts.
Fig. 173
. Maintain a 1/8" (3
Fig. 174
. Torque lower
Fig. 175
INSTALL AIR CLEANER ASSEMBLY
IMPORTANT
are slotted, Fig. 176.
3. Install fuel line from pump to carburetor
fuel pump pulse line at valve cover
4. Install thermostat and thermostat housing with
new gasket, Fig. 175. Torque screws to
.
(8.0 Nm)
5. Install radiator hoses.
: The air cleaner mounting bracket holes
• The front mounting hole
(radiator side).
• The rear mounting hole
(muffler side).
, and
, Fig. 174.
70 in. lbs.
is slotted crosswise
is slotted length wise
Page 67