INSTALLATION GUIDE • OWNER’S GUIDE REMOTE STARTER IMMOBILIZER • SILENT GUARD CONTENTS System Features ........1 System Components ........1 Required Tools ........1 Technical Assistance .........1 Before You Begin ........1 Precautions ........1-2 Making Connections .........2-3 Locating and Making Connections ....3-4 Antenna Placement ........4 How to use Your Remote Transmitter ....4...
It is computer controlled and manufactured in the U.S.A. The dependability and variety of features make Bulldog Security the leader in the industry. Enjoy your new system for years to come! We recommend you read this installation manual thoroughly before starting the installation. This manual will supply you with time-saving information.
DO NOT leave the interior or exterior lights on for an extended period of time as it may cause battery drain. Remove the dome light fuse from the vehicle’s fuse box. DO NOT mount the control module until all connections have been made and tested. Using wire ties or double sided tape MOUNT THE MODULE UNDER THE DRIVER’S DASH.
1. When tying two separate wires together at their ends, strip back 1” of insulation on both wires and separate the strands of wire as shown below. 2. Twist upper wires together, twist lower wires together as shown. 3. Lay upper twisted pair of wires over right wire as shown. Bring lower twisted pair of wires up to meet the left wire as shown.
STARTER INPUT / STARTER OUTPUT Locate the crank (starter solenoid) wire in the ignition harness, cut in two. Connect the wire marked #2 (starter input) to the vehicle’s factory crank wire from the ignition key side. Connect the wire marked #5 (starter output) to the other half of the factory crank wire leading out to the starter solenoid (engine).