Bios Setup - DFI 848P-AL User Manual

3.1.1.3 IDE Channel 0 Master, IDE Channel 0 Slave, IDE Channel 1
Master and IDE Channel 1 Slave
Move the cursor to the "IDE Channel 0 Master", "IDE Channel 0
Slave", "IDE Channel 1 Master" or "IDE Channel 1 Slave" field,
then press <Enter>.
Note:
The fields in this section will vary in accordance to the settings in
the "On-Chip Serial ATA" field ("OnChip IDE Device" section) of
the Integrated Peripherals submenu.
The settings on the screen are for reference only. Your version may not be identical
to this one.
IDE HDD Auto Detection
Detects the parameters of the drive. The parameters will auto-
matically be shown on the screen.
IDE Channel 0 Master/Slave and IDE Channel 1 Master/Slave
The drive type information should be included in the documenta-
tion from your hard disk vendor. If you select "Auto", the BIOS
will auto-detect the HDD & CD-ROM drive at the POST stage
and show the IDE for the HDD & CD-ROM drive. If a hard disk
has not been installed, select "None".

BIOS Setup

51
3