DFI 848P-AL User Manual page 44

2
Hardware Installation
2.6.7 Wake-On-LAN Connector
Your LAN card package should include a cable. Connect one end
of the cable to the wakeup header on the card and the other
end to location J7 on the system board. The network will detect
Magic Packet and assert a wakeup signal to power-up the system.
Refer to the add-in card's manual for details. Note: Your LAN card
must support the remote wake up function.
BIOS Setting
To use the Wake-On-LAN function, you must set the "Resume
On LAN" field ("PM Wake Up Events" section) in the Power
Management Setup submenu to Enabled.
44
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
Ground
+5VSB WOL
3
1