Adjusting Trim Angle (Power Trim And Tilt) - Yamaha E40X Owner's Manual

1. Trim rod
3. Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod to-
ward the transom.
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EWM00400
WARNING
Stop the engine before adjusting the
G
trim angle.
Use care to avoid being pinched when
G
removing or installing the rod.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
NOTE:
The outboard motor trim angle can be
changed approximately 4 degrees by shifting
the trim rod one hole.
EMU27883
Adjusting trim angle (Power trim and
tilt)
EWM00752
Be sure all people are clear of the out-
G
board motor when adjusting the tilt an-
1
gle. Body parts can be crushed
between the motor and the clamp
ZMU03063
bracket when the motor is trimmed or
tilted.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
If equipped with a power trim and tilt
G
switch located on the bottom cowling,
use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
switch while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
" " (up).
To lower the bow (trim-in), press the switch
" " (down).
Make test runs with the trim set to different
WARNING
Operation
39