Foxconn 760GXK8MC Manual page 25

Clear CMOS Jumper: CLS_CMOS
This motherboard uses the CMOS RAM to store
all the set parameters. The CMOS can be
cleared by removing the CMOS jumper.
How to clear CMOS?
1. Turn off the AC power supply and connect pins 1
and 2 together using the jumper cap.
2. Return the jumper setting to normal (pins 2 and 3
locked together with the jumper cap).
3. Turn the AC power supply back on.
Warning:
1. Disconnect the power cable before adjusting the jumper
settings.
2. Do not clear the CMOS while the system is turned on.
BIOS-Protection Jumper: FWH_EN
The motherboard BIOS is inside the FWH. If the
jumper FWH_EN is set as disabled (Pin2 &
Pin3), the system BIOS is protected from being
attacked by a serious virus, such as the CIH virus.
You will be unable to flash the BIOS to the
motherboard when the system BIOS is protected.
Chapter 2 Installation Instructions
Normal
(default)
Clear
Clear CMOS Jumper
Write Disable
Write Enable(default)
BIOS-Protection Jumper
1
2
3
1
2
3
1 2 3
1 2 3
19