Foxconn 760GXK8MC Manual page 21

1394 Connectors: F_1394_1, F_1394_2
(optional)
The 1394 expansion cable can be connected to
either the front (provided that the front panel of your
chassis is equipped with the appropriate interface)
or real panel of the chassis.
Wake-up On Modem: WOM
Through this function, systems in suspend or soft-
off mode can be waked up by a ring signal received
from the internal modem. When this function is
used, be sure an internal modem card which sup-
ports this function is used. Then connect the header
to the relevant connector on the modem card, set
"RING Power Up Control" to "Enabled" in the "Power
Management Setup" section of the CMOS SETUP.
Save and exit, then boot the operating system once
to make sure this function takes effect.
S-ATA Connectors: SATA-1, SATA-2 (optional)
The S-ATA Connector is used to connect the S-ATA
device to the motherboard.
These connectors support the thin Serial ATA cables
for primary storage devices. The current S-ATA in-
terface allows up to 150MB/s data transfer rate.
Chassis Intruder Connector: INTR
The connector connects to the chassis security
switch on the case. The system can detect the chas-
sis intrusion through the status of this connector. If
the connector has been closed once, the system
will send a message. To utilize this function, set
"Case Opened Warning" to "Enabled" in the "PC
Health Status" section of the CMOS Setup. Save and
exit, then boot the operating system once to make
sure this function takes effect.
Chapter 2 Installation Instructions
GND
12V
TPB -
GND
TPA -
F_1394
1
WOM
GND
TX+
TX-
GND
RX-
RX+
GND
SATA_1/SATA_2
1
INTR
Empty
12V
TPB +
GND
TPA +
1
Signal for waking up
GND
+5VSB
1
INTRUDERJ
GND
15