Pioneer XV-HTD510 Service Manual page 87

TRAVERSE MECHANISM ASSY-S
Disassembly
1 Remove the Bonnet (Screws × 7)
2
Remove the Tray Cap
Remove the Front Panel Section (Refer to "
Unhook
9
3
Power ON
4
Tray Open (0 OPEN/CLOSE)
5
Pull out the power cord from the outlet.
6
Push the Tray by hand. (about 5 cm)
7
Bring an extra flexible cable
close to the rear side.
8
Disconnect the flexible cable.
9 Unhook × 2
10
Pull out the tray
while pressing the two hooks (
When Tray Cannot Pull Out
Tray cannot pull out that is not at a position of home position.
(When two hooks ( 9 ) hide under the Rotary Tray
and can not pull out the tray.)
In that case, set the tray in the following procedures.
Note :
Do not need to match with Disc No. (1 to 5)
when returns the tray.
Detect it automatically.
FRONT PANEL SECTION")
CN12
7
).
9
10
6
1
Remove
3
Tighten
XV-HTD510, XV-HTD510-B
8
TRSB Assy
Tray Section
2
Rotary Tray
9
Unhook
Note :
The Traverse mechanism being
an unclamp (=down) state.
Set the tray to the position
that can see a hole of the center.
87