Digital Clock Function - S.E.M. Santos Z-7788 User Manual

DIGITAL CLOCK

DIGITAL CLOCK FUNCTION

The set has a built-in digital clock, which is displayed into 2 situations:
(1) When the set is in "standby mode" (the display will automatically always show the
correct time). In this situation, the blue backlight is dimmed (to save electricity) and you
can switch on the blue display light by pressing any key (on the set or remote control),
except the "on/ standby" key. This will activate the blue backlight for approximately 5
seconds.
(2) When the set is in "on mode" (the blue backlight of the display is "on" in this mode, to
indicate that the set is powered "on"). In this situation the LCD display normally does
not automatically show the current time. But you can press the "clock" key on the remote
control to display the current time on the LCD screen for approximately 5 seconds.
(3) How to set the correct time:
The unit must be in standby mode and the keys for setting the time found on the remote
control. Follow the below procedures:
Press and fold the Clock key for move then 2 seconds to enter into clock setting
mode.
While "CLK 12" or "CLK 24" is fl ashing, use the
the clock format. Once desired format is fl ashing, press the Clock key to confi rm
the selection.
Use the or
the setting.
Repeat above step to input & confi rm the "mm" selection. The clock will begin to
function after settings are complete
*Note:
During clock setting if no button is pressed within approx. 10 Seconds, the system will exit clock setting mode
automatically. The clock settings will be erased and need of resetting if power cord of unit is disconnected
or a power failure.
(4) Automatic wake-up
- This set has a time function which allows the system to switch on to disc, USB, card
or tuner mode automatically at a preset time, serving as an alarm to wake you up.
keys to set the "hh" (hour). Then press the Clock key to confi rm
or
E-4
keys to select between