Operation With Ipod - S.E.M. Santos Z-7788 User Manual

iPod OPERATION

OPERATION WITH iPod

- Connect the iPod docking platform with the Hi-Fi main unit.
- Connect the iPod to the iPod docking platform as described.
- Press the "function" key until the iPod docking platform shows a blue light.
- Press the Play
playback.
- The iPod display will indicate the information of the current song.
- At anytime during playback, press the Play
key to resume playback of the same song & position.
- Always press Play
- At anytime during playback, press and release the Next/Men+
key to skip forward or backwards by one song, as desired.
- At anytime during playback, press and hold the Next/Tune Up
Down key to fast-forward (cue) or fast-reverse (review) the specifi c song, which
is currently playing.
- You can operate the iPod using either the remote control or directly with the iPod itself.
- When the iPod has been connected with the unit, it will start charging the battery of the
iPod.
- Never remove (or unplug) the iPod from the set during playback, always hold the
Play key for a few seconds to turn off the iPod power and then press the "iPod/
AUX" key to switch to "AUX" mode before removing or unplugging the iPod, to prevent
damage to your song fi les or memory devices.
IPHONE® PLAYBACK
This unit also allows playback and charging of your iPhone.
However, when docking an iPhone, the unit may show a message indicating:
This accessory is not
intended for use with
iPhone (Non-Airplane mode)
Dismiss
key on the remote control, then the iPod docking platform to begin
key for a few seconds to stop operation of the set.
Press the 'Dismiss' onscreen button
to allow for normal playback.
key to pause playback. Press Play
E-24
or Back/Men-
or Back/Tune