Nilfisk-ALTO SCRUBTEC BOOST 8 Operator's Manual And Parts List page 19

HOW TO OPERATE THE MACHINE
WARNING: Water solutions or cleaning
materials used with this type of
machine can leave wet areas on the
floor surface. These areas can
cause a dangerous condition for the
operator or other persons. Always
put CAUTION signs near the area
you are cleaning.
WARNING: Machines can ignite flammable
materials and vapors. Do not use
with or near flammables such as
gasoline, grain dust, solvents and
thinners. Only use a cleaning
concentration recommended by the
chemical manufacturer.
WARNING: Nilfisk ALTO recommends a
maximum water temperature of
120 o F (49
Operating The Machine
NOTE: Put the machine in the lowest traverse speed
setting. Use the machine in an area that has no
furniture or objects until you can do the following:
1. Move the machine in a straight direction, forward and
backward.
2. Stop the machine safely.
3. Turn the machine both left and right and return to a
straight direction.
To move the machine, follow this procedure:
1. Release the parking brake (if equipped with
machine).
2. Turn the key switch to the "ON" position
3. Raise the brush.
4. Raise the squeegee.
5. When either the left or right forward palm buttons
(figure 20, item A) are pushed in, the machine will go
forward.
6. Control the speed of traverse by using the traverse
speed control knob (figure 20, item C).
7. To stop, release the forward palm buttons.
8. To reverse the machine, push in the white reverse
switch (figure 20 item B) and either the right or left
forward palm buttons (figure 20 item A) at the same
time.
9. To stop, release the forward palm buttons.
10. To turn the machine, push the rear of the machine to
the side.
11. When you stop the machine, turn the key switch
"OFF", remove the key and set the parking brake (if
equipped).
Nilfisk ALTO
Operator's Manual (EN) - SCRUBTEC 866, 871, 866, Boost 8 and 871C
o C).
ENGLISH
B
Figure 20
EN
A
A
C
- 19 -